How to Size a Generator for Your Home | Start With Watts

A generator’s running watts must cover every device you need at once, plus the single largest motor surge.

Two houses with identical appliance lists can need generators two thousand watts apart, and the gap is usually one compressor starting while the furnace blower already runs. Appliance labels, not square footage, decide how to size a generator for your home — the work is counting what runs at once, then adding one surge on top.

Which Appliances Have To Run At The Same Time?

Only the loads you plan to run simultaneously belong in the total. Ready.gov’s power outage guidance recommends deciding in advance which equipment matters most, because a generator may not carry every appliance at once.

  • Refrigerator and freezer
  • Lights, router, modem, and phone charging
  • Furnace blower, well pump, or sump pump
  • Medical equipment
  • Microwave or coffee maker, run one at a time

Read watts off each device’s label or manual. When only volts and amps are printed, multiply them to get watts. Equipment with a power-factor rating can pull volt-amperes above its real wattage, so use the manufacturer’s watt figure when one is listed.

The clothes dryer, electric range, and central air conditioning are the usual loads to leave off. If your list grows past what one unit can carry, cycle instead: run the well pump first, then the microwave, never both at once.

Sizing A Generator For Your Home: The Numbers That Decide It

Add the running watts of everything on at once, then add only the largest single startup surge among those loads. The generator’s rated running watts — not its peak figure — must cover that total, and Ready.gov’s power outage guidance frames the job around prioritized equipment rather than a fully powered panel.

Typical figures below are starting points only; your equipment’s label wins.

Equipment Typical Running Watts What Startup Adds
Refrigerator, 18 cu ft 600–800 2–3× running for a few seconds
Chest freezer 300–500 Compressor surge, similar ratio
Sump pump, 1/2 hp 800–1,000 Roughly double while starting
Well pump, 1/2 hp 750–1,000 2–3× running
Gas furnace blower 300–600 Motor start, smaller than a compressor
Window AC, 10,000 BTU 900–1,200 Compressor surge, often double
LED lights, router, chargers 100–200 None worth counting

Peak watts last seconds. Treating that burst rating as continuous capacity is the most common sizing mistake, and motor-driven equipment — refrigerators, freezers, sump and well pumps, furnace blowers, air conditioners — is where the hidden demand sits. Check the documentation or measure the draw rather than estimating it.

Altitude, high ambient temperature, and fuel choice all trim real output, and a propane or natural-gas model carries different ratings than the same unit on gasoline. A thin margin is worth sizing up for.

Voltage, phase, receptacle type, and breaker capacity have to match too. A generator’s advertised wattage says nothing about whether it fits your panel, your cords, or your fuel supply.

A portable generator feeds selected appliances through heavy-duty cords; a standby unit is wired through a transfer switch by a qualified electrician, and no generator should ever plug into a wall outlet to backfeed a house. Once the total is on paper, comparing models comes down to rated watts, receptacles, and fuel — our tested roundup of top ranked generators lists them on those specs.

Safety Rules That Override Wattage

No sizing math survives a generator running in the wrong place. Fuel-burning equipment stays outdoors, at least 20 feet from windows, doors, attached garages, and any other building opening.

  • Working carbon monoxide detectors with battery backup on every level of the home
  • A dry, covered spot away from rain, flooding, and standing water
  • Heavy-duty extension cords rated for the load they carry
  • A cool engine before refueling — spilled fuel ignites on hot parts
  • Never indoors: no garage, shed, porch, basement, or crawlspace

Shut off or unplug sensitive electronics before switching power sources to cut surge damage, and add surge protection where it fits. A transfer switch keeps generator power and utility power isolated so nothing backfeeds onto the lines.

Write the simultaneous total down, keep the biggest motor’s surge in the math, compare it against rated watts, and let the 20-foot rule and a licensed transfer-switch install handle the rest.

Common Questions

What Size Generator Runs A Whole House?

There is no universal number. A whole-house standby is sized from the same simultaneous-demand math, and central air conditioning usually drives the figure. An electrician performs a load calculation at the panel and matches the transfer switch and breaker capacity to it, which is why whole-house sizing belongs to an installed system rather than a portable unit.

Do I Add Every Motor’s Starting Watts?

No. Add only the largest single startup surge to the running total unless your plan requires two big motors starting together. A refrigerator and a furnace blower cycling separately count as one surge. If they can start at the same instant, add both or stage the starts by switching one load on before the other.

Is Oversizing A Generator Bad?

A larger generator does not push extra power into appliances; each device draws what it needs. Excess capacity mostly costs fuel, weight, and money, and a very lightly loaded unit can run inefficiently. Sizing slightly above your calculated total gives margin for derating without paying for capacity you will never use.

Sources

  • Ready.gov (FEMA). “Power Outages” Covers prioritizing equipment during an outage and generator safety, including outdoor placement and carbon monoxide detection.

Scroll to Top