Size a pop-up camper solar array by dividing daily watt-hours by peak-sun hours times 0.70, then match the battery to your overnight loads.
Size the system around measured watt-hours, not camper length or panel brand.
Pop-up roofs are short, crossed by vents and air conditioners, and often hold only 100–200 W of glass — so accurate load counting and careful sun-hour planning are non-negotiable.
How Many Watt-Hours Does Your Camper Actually Use?
A pop-up camper typically burns 400 to 1,200 watt-hours a day. Find your figure by multiplying each device’s watts by its daily run time and adding the results.
Go Power’s guide says to list every DC and AC appliance, its hours, and the running total before picking hardware. The forgotten devices break the math: a propane furnace blower can run all night on a cold trip, and the water pump cycles with every hand wash. Add the propane detector, fridge controls, LED lights, USB charging, and inverter idle draw — an inverter left on often burns 10–20 W around the clock, or 240–480 Wh a day before powering anything.
Anything on a household outlet — laptop charger, blender, CPAP supply — runs through an inverter, costing roughly 10–15% of the energy on top. A 30% allowance covers controller, wiring, battery, and conversion losses.
Sizing A Solar Panel System For A Pop-Up Camper: Sun Hours And Array Watts
Divide daily watt-hours by peak-sun hours times 0.70 for the panel wattage to shop for. A camper burning 950 Wh needs about 339 W at four peak-sun hours: 950 ÷ (4 × 0.70) = 339 W.
Peak-sun hours aren’t daylight hours — they measure equivalent hours of full-strength sun and swing with season and latitude. Go Power’s worksheet assumes six charging hours but warns output shifts with season, location, and weather; its RV solar reference guide sets out those variables. Four hours is a safer default across most of the continental U.S.
Nominal ratings are lab figures. Shade from the raised fabric, roof air conditioner, or a vent can halve output, and hot panels produce less than cool ones. Oversize slightly — two 100 W panels matched to a 200 W load leave no margin for a cloudy afternoon.
| Daily Watt-Hours | Panel Watts (4 Sun Hours) | What Fits A Pop-Up Roof |
|---|---|---|
| 400 | 143 W | One 150 W panel |
| 600 | 214 W | Two 100 W panels, no margin |
| 800 | 286 W | Two 150 W panels |
| 950 | 339 W | Two 175 W panels |
| 1,200 | 429 W | Three 150 W panels |
| 1,500 | 536 W | Roof array plus a portable |
| 2,000 | 714 W | Not practical on most roofs |
Battery Amp-Hours, Controller Limits, And Roof Reality
Battery size and controller rating are separate from panel wattage. A 12 V bank needs roughly daily watt-hours times backup days, divided by 12, in amp-hours: a 950 Wh day with one day of reserve wants about 79 Ah usable; two days, about 158 Ah.
Usable capacity runs below the label. Lithium delivers close to rated amp-hours; flooded lead-acid and AGM are usually kept to about half to protect cycle life — a 100 Ah AGM is closer to 50 usable amp-hours. Check the manufacturer’s depth-of-discharge limit.
The charge controller must accept the array’s maximum voltage and current, not just wattage. In series, panels’ open-circuit voltages add — the figure Victron Energy flags as a sizing criterion. Match the charging profile to battery chemistry and fuse the positive conductor near the battery.
Roof space usually settles the answer: pop-up and teardrop roofs commonly top out around 100–200 W once structure, panel dimensions, and the lifting mechanism are accounted for. A crowded or shaded roof does better with a portable panel on a long lead; our tested solar panel picks for pop-up campers cover the models built for that layout.
Run the numbers in order — daily watt-hours, peak-sun hours, panel watts, battery amp-hours, controller open-circuit voltage — and every purchase becomes a fit check rather than a guess. Leave the air conditioner, microwave, and coffee maker off the list; this array size runs lights, fans, phones, a fridge, and a furnace blower.
Common Questions
Can a single 100 W panel keep up with a small camper?
Do I need an inverter for this setup?
Only for 120-volt appliances. Lights, fans, a 12 V fridge, and the furnace blower run straight off the camper battery, so an inverter adds cost and idle draw for nothing. Add one for a laptop charger, CPAP supply, or other AC device, and size it for their surge.
How long will the battery last once the sun drops?
Storage is set by amp-hours, not panel watts. A lead-acid bank of the same rating gives closer to half that before voltage sags.
Sources
- Go Power. “RV Solar Reference Guide” Load inventory worksheet and the charging-hour assumptions used in the sizing steps.
- Victron Energy. “How to Size a Solar System for Your RV” Peak-sun-hour method and combined open-circuit voltage as a controller sizing criterion.
- RV.com. “How Much Solar Do I Need on My RV?” Inverter losses and load accounting for AC appliances.