Sizing a small solar kit comes down to four figures: daily watt-hours of energy, peak simultaneous watts, usable battery storage, and your local peak-sun hours.
One wrong number and the kit underperforms every cloudy week. The good news: you can nail all four with a pen, a label-reading session, and about twenty minutes. The order matters too — energy first, then power, then storage, then panels — because each figure feeds the next.
Below is the same method the U.S. Department of Energy lays out in its small-scale renewable energy sizing guidance, translated into a kitchen-table workflow. Do the math once and every product listing you open afterward gets easy to judge.
Step 1: Build A Load Inventory
List every device the kit will run and note its watts and daily hours. Include the small stuff — phone chargers, a router, LED lights — because standby draw adds up over 24 hours even when nothing is “on.”
Find watts on the device label or power brick. If the label lists only volts and amps, multiply them: watts = volts × amps. A 12 V device drawing 2 A is a 24 W load. Write the hours you actually expect each item to run per day, not the maximum.
Step 2: Total Daily Energy In Watt-Hours
Multiply each device’s wattage by its daily hours, then add everything together. A 60 W device used five hours a day consumes 300 Wh, and the sum across all devices is your daily energy demand.
Energy is watt-hours, not watts — that distinction is the single most common sizing mistake. A 100 W panel doesn’t “make 100 W of energy”; the energy is what accumulates over hours of sunlight. Keep your total in one place, because both the battery and the panel array get sized from it.
| Device | Watts × Daily Hours | Daily Watt-Hours |
|---|---|---|
| LED light (×2) | 10 W × 5 h | 100 Wh |
| Phone and tablet charging | 20 W × 3 h | 60 Wh |
| Laptop | 60 W × 4 h | 240 Wh |
| 12 V fridge (cyclic) | 45 W × 8 h avg | 360 Wh |
| Wi-Fi router (24 h standby) | 7 W × 24 h | 168 Wh |
| Fan | 25 W × 6 h | 150 Wh |
| Daily total | — | 1,078 Wh |
Step 3: Peak Watts And Battery Storage
Add the running watts of everything that could be on at the same time, then check the surge rating of any motor-driven item. Inverters must cover that continuous load plus the brief startup spike from fridges, pumps, and power tools.
Energy totals say nothing about surge. Check the nameplate or manual for each motor device — there’s no universal multiplier to apply blind.
Sizing The Battery Bank
Base the battery on usable energy, not nameplate capacity. For off-grid use, the Department of Energy’s guidance sizes battery banks around one to three days of autonomy, with longer cloudy stretches requiring more.
Sizing The PV Array
Divide daily watt-hours by your location’s peak-sun-hours figure, then add a margin for wiring, heat, dust, shading, and charging losses. A 1,078 Wh day in a spot with four peak-sun hours lands near 270 W before losses — budget meaningfully more panel than that.
Panel ratings are ideal-condition numbers. Tilt, orientation, season, and shade move real output far more than the label suggests. For tested hardware that matches your calculated wattage, see this roundup of the best small solar kit options before you buy.
Where Most Small Kit Plans Fall Apart
Several quiet losses wreck an otherwise sound calculation: nights with zero sun, inverter idle draw, cold batteries losing usable capacity, and panels rated for perfect conditions.
- Counting battery nameplate kWh as fully usable — depth of discharge and aging cut deep into it.
- Sizing the inverter off average consumption while ignoring simultaneous loads and motor startup.
- Forgetting nighttime and standby loads, which run while the panels produce nothing.
- Treating a panel’s rated watts as guaranteed daily output.
One more honest point: there’s no universal kit size. Real sizing depends on your loads, your climate, and your components.
The arithmetic behind all of this follows the Department of Energy’s small-scale renewable sizing guide, which walks through the load-calculation method step by step.
Common Questions
How many peak-sun hours should I assume?
Use a location-specific figure rather than a national average. Much of the U.S. Southwest sees six or more usable hours, while northern and cloudy regions often model closer to three or four. Weather, season, and panel tilt all shift the number, so model conservatively and add margin to the array rather than cutting it fine.
Can I run a fridge on a small kit?
Sometimes, but it dominates the load. A 12 V fridge cycling eight hours a day can consume roughly 360 Wh — about a third of a modest system’s daily budget. It also adds a startup surge the inverter must handle. Size the array and battery around the fridge first, then fit everything else into what remains.
Do I need one day of autonomy or three?
One day covers a single cloudy stretch; three days handles a longer storm pattern without draining the bank. The Department of Energy’s guidance places typical off-grid sizing at one to three days of operation, so pick your figure based on how bad the weather gets where you live and how much you dislike running a generator.
Sources
- U.S. Department of Energy. “Sizing Small-Scale Renewable Energy Systems.” Supports the four-quantity sizing method, autonomy guidance, and case-study figures.
- U.S. Department of Energy. “Solar Energy Technologies Program: Battery Sizing.” Supports usable-capacity and depth-of-discharge battery calculations.