IP65 vs IP66 vs IP67: Weatherproof Security Camera Ratings Explained

All three ratings are dust-tight, so the real difference is water: IP65 handles jets, IP66 handles stronger jets, and IP67 handles a 1-meter dunk.

A camera sold as “weatherproof” tells you little until you find the two digits on the spec sheet. Those digits decide whether a unit survives a coastal downpour and whether it survives the puddle under a gutter leak — and IP67 is not simply “better” than IP65. IEC 60529 defines the codes: the first numeral covers solids, the second liquids. All three start with 6, so dust is solved in every one.

What Separates IP65, IP66, And IP67?

The second digit sets the water test, and each test measures a different exposure rather than a step up the same ladder.

Rating Water Test Conditions Real-World Fit
IP65 6.3-mm nozzle, 12.5 L/min, roughly 30 kPa, about 3 m, 3+ minutes Sheltered walls, eaves, ordinary rain and spray
IP66 12.5-mm nozzle, 100 L/min, roughly 100 kPa, about 3 m, 3+ minutes Fully exposed walls and poles, driving rain, directed spray
IP67 Temporary immersion up to 1 m for 30 minutes Pooling water, flooding risk, accidental drops into standing water
IP65 Not tested for immersion Never submerge, even briefly
IP66 Not tested for immersion Never submerge, even briefly
IP67 Not tested for powerful jets Do not pressure-wash on the strength of IP67 alone
IP66/IP67 Both tests passed Best choice when jets and standing water are both plausible

That last row matters. IP67’s dunk test says nothing about a hard jet at the seams, and IP66 says nothing about submersion. A dual marking means both tests were run.

Why A Higher IP Rating Doesn’t Cover Everything

An IP rating covers dust and water ingress only; freezing cold, salt air, direct sun, condensation, and chemicals sit outside it. The IEC frames these codes as enclosure classifications for dust and liquids — nothing broader. That gap is where most outdoor camera failures start. Check the stated operating-temperature range, confirm corrosion resistance for coastal installs, and read the installation manual. Reolink explains its IP65, IP66, and IP67 ratings in exactly these jet-and-immersion terms and points customers to the Spec section of each model page for the stated figure.

Two more boundaries: IP67 is temporary immersion only — continuous underwater use requires IP68, whose conditions the manufacturer defines. And the rating lives on the camera body; seals on cable glands, connectors, junction boxes, and unused ports are the installer’s job. A perfectly rated camera on a sloppy cable run still floods.

Which Rating Fits Your Install?

Match the rating to the water the camera will actually meet. Overspending on IP67 for a sheltered porch buys protection you will never use, while an IP65 unit under an exposed roofline asks for trouble.

  • IP65 — under an eave, a porch ceiling, or a wall that gets rain but no direct blast.
  • IP66 — an open exterior wall, a pole mount, or anywhere wind drives rain sideways. ACTi rates its outdoor cameras at IP66 minimum, with many models at IP67 or IP68.
  • IP67 — ground-level spots, low mounts near paving, or anywhere water pools after a storm.
  • IP66/IP67 — the honest pick when exposure is unpredictable.

Never pressure-wash an IP65 or IP66 camera unless the maker says otherwise, and mount it in the orientation the manual specifies so water cannot sit against seams, microphones, or reset buttons. To see how these ratings land on real hardware, our roundup of tested weatherproof security cameras sorts models by rated exposure and mounting position.

Finally, an IP rating says nothing about PoE, NVR or ONVIF support, app compatibility, or warranty terms. Water damage from improper sealing or exceeded immersion limits is commonly excluded.

Common Questions

Is IP67 better than IP66 for an outdoor camera?

Not automatically. IP67 adds temporary immersion protection up to 1 meter for 30 minutes but is not tested against powerful water jets, which is what IP66 covers. For an exposed wall taking driving rain or spray, IP66 is the more relevant rating; where water pools, IP67 matters more. A camera marked IP66/IP67 has passed both.

Can I hose down an IP65 camera?

Only within limits. A pressure washer is well beyond that test and can force water past seals that passed the lab. Follow the manufacturer’s cleaning instructions and never submerge an IP65 unit.

Does a weatherproof camera rating cover cold or salt air?

No. IP codes cover dust and water ingress only. Freezing temperatures, extreme heat, salt corrosion, condensation, and prolonged sun exposure all fall outside the rating, so check operating-temperature and corrosion specs separately — especially for coastal or industrial installs.

Sources

Scroll to Top