How to Wall Mount an Xbox Series X | Step-by-Step Setup

Microsoft publishes no wall-mount kit for the Series X, so the job takes a third-party bracket rated for its weight, ports, and vents.

Wall mounting an Xbox Series X comes down to one piece of hardware Microsoft doesn’t make: a bracket built for the console’s exact weight and vent layout. Skip one and you’re pricing a repair.

Which Xbox Series X Are You Hanging?

Three variants share one shell, and the weight gap between them is what your bracket has to cover. Check the label before you order anything.

All three measure 15.1 cm by 15.1 cm by 30.1 cm, so fit comes down to depth, vent clearance, and how the mount grips the shell. Microsoft doesn’t list a separate figure for the 2TB Galaxy Black edition, which uses the same disc-drive body — plan for roughly 9.8 pounds. Those prices are suggested retail and shift with the retailer.

Spec sheets rarely tell you how a bracket behaves once a console is hanging on it, so our roundup of tested Xbox Series X wall mounts is sorted by weight rating and vent clearance.

Wall Mounting An Xbox Series X: Sizing, Studs, And Clearance

Drill only after the studs are marked and the cables are planned, because a bracket that lands an inch off takes the whole layout with it.

1. Pick a bracket rated for Xbox Series X.
2. Find the studs with a stud finder and mark their centers against the bracket’s screw holes. On masonry, use an anchor system rated above the combined bracket and console weight.
3. Dry-fit the bracket and trace the cable paths. Power, HDMI, Ethernet, and the storage expansion slot each need room to bend without pulling.
4. Check the vent gap before drilling. The Xbox Series X|S FAQ covers console ventilation; the short version is that the top grille and rear fan cannot sit against drywall or inside an enclosure.
5. Fasten the bracket with the hardware it shipped with, level it, then push sideways on it. Any twist or gap at the wall means those fasteners are wrong for that surface.
6. Seat the console in the mount and engage every strap, lip, and locking screw. Nothing should press on a vent, and the disc slot needs a clear path on the disc-drive model.
7. Hang the cables with slack, looping the excess to the wall rather than the console.

Push the console gently once everything is connected. Power on and confirm video, network, controller pairing, and disc loading if you have the disc model.

Where Mounts Go Wrong After The Screws Are Tight

Most wall-mount problems show up weeks later, and heat is usually behind them. A console hung grille-down against drywall, boxed into a shelf, or parked above a radiator pulls its own exhaust back in.

Two rules from Microsoft’s safety documentation matter here: never drill into the console housing or use its vents as mounting points, and never run it near a heat source or where dust and moisture collect. Vertical or horizontal is your call — the bracket has to hold the console either way without choking airflow.

Warranty is the quieter risk. A third-party mount that lets go is not a Microsoft defect, and a cracked shell from a fall rarely qualifies as a repair.