A pour-over set brews by gravity: a rinsed paper filter holds medium-fine grounds in a dripper, and staged pours of hot water drain into your cup in about 3 to 4 minutes.
Two things decide whether the cup tastes sweet or muddy: the ratio you weigh and how gently you pour. Hario’s V60 guidance settles both — a 1:16 coffee-to-water ratio and intermittent pouring — so a first attempt can land close to a good cup. Below is the timed sequence, plus recipes from James Hoffmann and Hario’s Camber Coffee.
What Do You Need Before The First Pour?
A working set needs five things: a dripper, the correctly sized paper filter, a heat-safe cup or server, freshly ground coffee, and hot water. A scale and timer make results repeatable; a gooseneck kettle improves control but isn’t required by Hario.
Filter size is the mistake that ruins first brews. The Hario Alpha Series V60-01 is a 1–2 cup dripper, so it takes V60-01 filters only. Hario makes it from shatter-resistant Tritan, lists product numbers ADT-01-B, ADT-01-TB, ADT-01-BG, and ADT-01-AB, and notes it does not fit the SWITCH Base.
If you haven’t bought anything yet, the tested pour over coffee set roundup covers which drippers, filters, and kettles hold up in daily use.
How Do You Brew A Single Cup, Step By Step?
The standard V60 method runs water at roughly 194°F (90°C) through 12.5 g of coffee and 200 g of water at a 1:16 ratio, blooming first, then pouring in stages, for a total brew time of 3–4 minutes. Hario’s Alpha Series instructions specify exactly this sequence:
- Heat water to about 194°F; Hario permits adjusting to taste.
- Seat a V60-01 paper filter and wet it — rinsing removes paper taste.
- Weigh 12.5 g of coffee, grind medium-fine, and level the bed.
- Bloom with 2–3 times the coffee’s weight in water, about 25–37.5 g.
- Wait 30–45 seconds while the grounds degas.
- Add the remaining water in intermittent pours, finishing the main pour around 1:15–1:30.
- Let it drain; total brewing time should land in the 3–4 minute range.
You’ll know it worked when the bed settles flat and slightly domed, the dripper stops dripping, and the brew weighs close to target.
| Recipe | Coffee / Water | Target Finish |
|---|---|---|
| Hario Alpha V60-01 standard | 12.5 g / 200 g | 3–4 minutes |
| James Hoffmann one-cup | 15 g / 250 g | ~3:00 drawdown |
| James Hoffmann larger batch | 30 g / 500 mL | ~3:30 |
| Camber Coffee (Hario USA) | 20 g / 345 g | 3:00–3:15 |
What Does The Hoffmann Pour Schedule Look Like?
James Hoffmann’s one-cup Hario recipe uses 15 g of medium-fine coffee and 250 g of freshly boiled, soft filtered water in four staged additions with gentle swirls:
- 0:00 — pour 50 g for the bloom.
- 0:10–0:15 — swirl gently.
- 0:45 — bloom ends; pour to 100 g by 1:00.
- 1:10–1:20 — pause, then pour to 150 g.
- 1:30–1:40 — pause, then pour to 200 g.
- 1:50–2:00 — pour to 250 g.
- 2:00–2:05 — swirl and drain, expecting roughly 3:00.
For a larger batch, his Hario recipe scales to 30 g and 500 mL of water just off the boil. Make a central well, bloom with 60 g for up to 45 seconds, pour to 300 g, then 500 g, stirring once clockwise and once counterclockwise after the final pour. Target about 3:30.
Hario’s Camber Coffee recipe uses 20 g medium-fine coffee and 345 g water: a 60 g bloom to 0:30, a pour to 200 g by 0:45, and a final pour to 345 g at 1:00, finishing in 3:00–3:15. Browse Hario’s recipes and guides for full published versions.
Why Does Your Pour-Over Taste Wrong?
Most failed brews trace to one of five causes, each with a direct fix:
- Papery or dull flavor — rinse the filter first.
- Water bypassing the grounds — use V60-01 filters in a V60-01 dripper.
- Flat, hollow taste — bloom with 2–3 times the coffee’s weight and wait 30–45 seconds.
- Channeling and gushers — slow the pour; staged additions beat one fast dump.
- Brew finishing far too fast or slow — adjust grind; recipes assume medium-fine.
Treat 3–4 minutes as a range, not a verdict — recipes target 3:00 to 3:30 and variation is normal. Weighing your water makes this repeatable, and Hario explicitly allows adjusting ratio and temperature to taste once the base method is consistent.
Set the server on a stable, heat-safe surface, and remember the Tritan dripper is shatter-resistant, not unbreakable.
Common Questions
Do I Need A Gooseneck Kettle To Start?
No. Hario’s instructions don’t require one, and a standard kettle works for a first brew. A gooseneck spout gives finer control over pour rate and placement, which helps once you’re chasing consistency. Start with a narrow-spout kettle if you own one and upgrade only if pouring control becomes the limiting factor.
Can I Brew More Than One Cup At A Time?
Yes, up to the dripper’s rated capacity. Hoffmann’s larger recipe uses 30 g of coffee and 500 mL of water with the same medium-fine grind, a 60 g bloom, and a target finish near 3:30.
How Fine Should The Coffee Be Ground?
Medium-fine, matching the published recipes. Grind affects drainage directly: finishing well under 3 minutes suggests too coarse, stalling past 4 minutes too fine. Change one variable at a time so you can taste what moved.
Sources
- Hario USA. “Alpha Series Dripper 01” Source for the V60-01 specs, Tritan material, filter compatibility, and SWITCH Base note.
- Hario USA. “James Hoffmann – Ultimate V60 Technique” Source for the one-cup pour schedule and the 30 g / 500 mL batch method.
- Hario USA. “Recipes and Guides” Source for the standard V60 method and the Camber Coffee recipe.