What Is a USB-C In-Wall Outlet and How Does It Work? | Charging Ports Built In

A USB-C in-wall outlet is a permanently wired receptacle that adds built-in USB-C charging ports alongside standard AC outlets, converting household current into regulated DC power.

One less charger brick on the counter is the appeal, but the outlet underneath the wallplate matters more than the port count. These devices wire straight into the branch circuit, and the better models use USB Power Delivery to negotiate voltage with whatever gets plugged in. Whether that matters for a phone, a tablet, or a laptop comes down to how much wattage the model actually delivers — and whether the wall box behind it has room.

What Does A USB-C In-Wall Outlet Actually Do?

The outlet combines a normal US grounded receptacle with one or more USB-C ports fed by an internal power supply, so no separate charger is needed. The AC half typically stays a 15A, 125V tamper-resistant receptacle with the standard NEMA 5-15R configuration.

Leviton’s USB-C with Power Delivery line follows that pattern: the AC receptacle works exactly as before, while the USB ports convert AC to low-voltage DC on their own circuit. That internal supply is the whole point. A plug-in charger takes up an outlet and adds clutter; a wired version does the same job out of sight.

One limit surprises people. These ports charge and nothing else. Leviton states that its 60W USB-A/USB-C in-wall charger has “no data transfer capability,” which means no syncing, no display output, no network connection — just power.

How Does USB Power Delivery Change The Output?

PD outlets negotiate with the connected device, choosing a voltage and current profile the device supports instead of forcing one fixed output. Leviton’s 60W dual USB-C model supports 5VDC, 9VDC, 15VDC, and 20VDC; with a single PD device attached, documented examples include 9VDC at 3A (27W), 15VDC at 3A (45W), and 20VDC at 3A (60W).

Two ports change the math. Shared output usually splits the total, so the T5636-W gives up to 60W from one port but up to 30W per port when both are occupied. The 30W T5635-T drops to 15W per port with two devices charging. A non-PD USB-C device still charges, just at lower standard USB levels.

Which Wattage Do You Actually Need?

Match the outlet to the hungriest device that will live near it, then accept the split when two things charge at once. A phone tops out well below 30W in most cases; a tablet or a small laptop wants 45W or more to charge at reasonable speed.

Leviton Model USB Output Best For
T5636-W (dual USB-C PD) 60W total; 60W one port, 30W per port two devices Laptop plus phone
CC1P6-E (dual USB-C PD, GaN) 60W total; up to 30W per port two devices High-wattage desk area
T5635-T (dual USB-C PD) 30W total; 30W one port, 15W per port two devices Phones and tablets
T5634-B (USB-A + USB-C PD) USB-C up to 50W; USB-A 5V at 2A (10W) Mixed cables
ECC20-W (dual USB-C) 30W total; up to 15W per port 20A circuits

Two buying notes. The ECC20-W uses a 20A, 125V NEMA 5-20R receptacle and takes 10- or 12-AWG copper wire, so it suits a 20A circuit rather than a standard 15A one. And finish, model, and retailer all move the price, so check a current listing before budgeting.

What Should You Know Before Installing One?

Box capacity decides whether the job is simple or a wall repair. Leviton’s instruction sheet requires a wall box with at least 20 cubic inches of capacity, wiring consistent with NEC Article 314 and applicable box-fill requirements; the 60W T5636-W specifically needs an extra-deep 20-cubic-inch box or a wall-box extender.

For readers comparing models before committing, this roundup of tested USB-C in-wall outlet picks narrows the field by wattage and box fit.

  • Kill the power first. Switch off the breaker, then verify the circuit is dead before touching any conductor.
  • Match the wiring. Connect the device conductors per the included instructions, mount with the supplied screws, and fit the wallplate.
  • Restore and test. Power returns at the breaker; the AC receptacle and both USB ports should charge right away.
  • Check local rules. Permits and code requirements vary by jurisdiction, and some areas restrict DIY receptacle swaps.

Skip one habit and the rest stops mattering: a tamper-resistant AC receptacle does not make the USB electronics weatherproof, and nothing in Leviton’s specs establishes wet-location or outdoor approval. These are US residential devices built around 125V NEMA receptacles, not a substitute for another region’s electrical system. Leviton’s USB-C Power Delivery outlet specifications list the full model range and their documented ratings.

Common Questions

Can a USB-C wall outlet fast-charge a laptop?

It can, if the model supplies enough wattage and the laptop supports USB Power Delivery. Leviton’s 60W models reach 60W from a single port, enough for many thin laptops, while 30W models charge them slowly or only while idle. Cable capability matters too, since a low-rated cable caps the current the outlet can push.

Do I need an electrician to swap one in?

Not always, but the swap is still electrical work at line voltage. The task requires cutting power at the breaker, verifying the circuit is dead, and confirming the existing box meets the 20-cubic-inch capacity requirement. Local permitting rules decide whether a homeowner can legally do it, so check before starting.

Will a USB-C outlet charge an older USB-A device?

Yes, with an adapter. Leviton states its dual USB-C outlet can charge Type-A devices through one. Charging happens at standard USB levels rather than a PD profile, so expect ordinary speeds rather than the outlet’s peak output.

Sources

Scroll to Top