A glance at a round shows where the axe should land, and a strike that follows an existing crack takes far less force than a knot-defying swing. The sequence below runs from site setup to embedded-axe recovery, so the first log and the fiftieth get the same controlled treatment.
Set Up the Work Area Before the First Swing
A safe splitting site is flat, open ground with room for a full swing and no one inside that arc. Stihl’s firewood guidance puts work area and footing first on its checklist.
- Clear branches, rocks, roots, and holes from where you stand and where the axe travels.
- Set the chopping block on level ground — never on a slope, a wobbly stump, or a ladder.
- Keep bystanders, kids, and dogs well behind you, not beside the block.
- Skip the job if you’re tired, sick, or affected by alcohol, drugs, or medication — Stihl’s work-safety tips single this out.
- Inspect the axe head and handle before each session; a cracked haft or loose head means the tool stays in the shed.
Eye protection and work gloves matter more than they seem — splitting throws chips and bark fragments, and the round itself can spit splinters on a hard strike.
Read the Round, Then Place It
Grain and cracks decide where the axe lands, so inspect each round before lifting it onto the block. Cut ends should be flat and square so the round stands on its own.
Look for hairline cracks across the end grain and aim straight down them. Avoid knots and branch stubs entirely: they redirect the grain and turn an easy split into a fight. Stihl names hickory and elm as the knotty, gnarly species that resist splitting hardest, so expect more effort or a wedge.
Shorter rounds split more easily than long ones — worth remembering when bucking logs to length. Once the round is on the block, set it upright and push it as far from your body as practical; that placement sends a missed strike into the block instead of toward your shins.
The Swing: Grip, Alignment, Follow-Through
Grip the axe with both hands, keep both arms straight through the swing, and drive the bit toward the center of the round or an existing crack. Watch your distance from the wood as the head comes down.
Hands above or below the handle line mean an off-angle strike — reset your stance rather than forcing it.
Controlled swings beat hard ones. A steady, repeatable stroke keeps the edge on target and your shoulders intact; muscling the axe is how people miss, glance off, and lose control of the tool.
When the Axe Sticks, and When to Reach for a Wedge
A large round often swallows the bit and stays put. Stihl’s recovery method: lift the round by the axe handle, swing it behind your shoulder with the axe butt pointing up, then bring the butt down onto the block — never a free swing, since the wood can fly off the head.
That recovery is riskier than an ordinary strike, so treat it as a last resort for big rounds. For oversized or stubborn pieces, a twisted splitting wedge driven with a maul gives more control;
| Situation | Tool That Fits | Why It Works |
|---|---|---|
| Standard rounds, easy grain | Woodcutter splitting maul | Built for routine splitting tasks |
| Large logs, clean grain | Pro splitting axe | Recommended for bigger logs |
| Big rounds, tough species | Pro splitting maul | Hickory handle with a steel sleeve for overstrikes |
| Oversized or twisted rounds | Twisted splitting wedge + maul | 45-degree wedge angle adds leverage |
| Knotty hickory or elm | Wedge first, axe second | Knots redirect grain and stall the bit |
| Axe embedded in the round | Same axe, butt-down method |
Matching the tool to the round matters as much as the swing, and if you’re still working with a hardware-store axe that bounces off every log, it’s worth comparing a top rated wood splitting axe built for real firewood work before the next cord.
Every technique above traces back to manufacturer guidance. Stihl’s firewood splitting guide lays out the block height, the crack-reading step, and the embedded-axe method in the same order covered here.
Common Questions
How high should the chopping block be?
No higher than your knee. A low block keeps the strike zone below your waist, so the axe finishes its arc in wood or block rather than near your body. A tall block forces an awkward downward chop and costs you control on every swing.
Why does my axe bounce off instead of biting?
Usually the strike landed on a knot, off the grain, or with a loose grip. Check the round for a crack and aim straight down it, keep both arms straight, and confirm the handle sits horizontal as the bit enters. A dull edge makes bouncing worse.
Do I need a wedge or a maul?
Only for rounds that resist the axe — oversized pieces, twisted grain, or knotty species like hickory and elm. A twisted wedge driven with a splitting maul gives leverage the axe alone can’t, and it’s safer than forcing a stuck bit free.
Sources
- Stihl. “Firewood Tips” Source for block height, crack-reading, grain alignment, swing technique, and the embedded-axe recovery method.
- Stihl. “Work Safety Tips” Source for footing, impairment, and equipment-inspection guidance.
- Stihl. “Safety Manuals” Manufacturer manuals for equipment-specific safety direction.