A range hood should be at least as wide as your cooktop, and Broan’s guidance pairs a 30-inch cooktop with a 30- to 36-inch hood.
Buy the hood by the cooking surface’s actual width, not the cabinet opening, and a 36-inch range needs a hood no narrower than 36 inches. Getting that width right keeps smoke, steam, and grease from sliding around the sides and settling on your cabinets. The size you pick also decides airflow, mounting height, and whether the hood even fits under the cabinets, so work through the numbers before you buy.
How Wide Should A White Kitchen Hood Be Compared To The Range?
Match the hood to the cooktop’s measured width, then size upward, never down. Broan’s published ranges pair each cooking surface with a practical hood width.
- 24-inch cooktop: 24- to 30-inch hood
- 30-inch cooktop: 30- to 36-inch hood
- 36-inch cooktop: 36- to 42-inch hood
- 48-inch cooktop: 48 inches or wider
A hood 3 to 6 inches wider than the cooking surface improves side capture, which matters most over high-heat burners and on installs mounted higher than usual. A hood narrower than the cooktop is the one mistake that undoes everything else: smoke and odors escape past the edges no matter how strong the fan is. Measure the burners or elements themselves, not the cabinet cutout. Inserts and liners are the exception, since they sometimes need to be narrower than the cooktop to fit inside the enclosure. Check the cabinet interior dimensions against the product manual before ordering.
What CFM Does Your Cooktop Actually Need?
Width sets capture; CFM sets removal, and Broan ties airflow to fuel type and burner output. For electric cooktops and gas cooktops under 60,000 BTU, allow at least 100 CFM per linear foot of cooking surface, so a 36-inch cooktop needs 300 CFM minimum. Above 60,000 BTU, estimate 1 CFM per 100 BTU, which puts a 65,000-BTU cooktop at 650 CFM. Add 200 CFM if the cooktop has a grill or griddle.
Broan also frames airflow by cooking style: 250–400 CFM for light cooking, 400–600 CFM for everyday meals, 600+ CFM for frequent high-heat work, and 900+ CFM for professional-style ranges. Gas and high-output burners generally need more pull than electric or induction.
Where Should The Hood Sit, And What Changes With Height?
Broan’s general target is 24 to 30 inches from the cooking surface to the bottom of the hood, unless the specific manual says otherwise. Mount it higher and capture suffers, so Broan recommends adding 100 CFM for every extra 3 inches of height, and/or going at least 3 inches wider on the hood or liner.
Ventilation type matters just as much. Ducted hoods push air outdoors. Ductless models recirculate through a charcoal or mesh filter and cannot match outdoor exhaust for moisture and combustion byproducts, which is worth weighing for any gas range. Confirm the duct dimensions, damper, electrical requirements, and mounting hardware in the exact installation manual, and keep local building codes in mind: high-CFM hoods may trigger makeup-air requirements.
| Hood Model | Width And Airflow | Best For |
|---|---|---|
| Broan-NuTone 412401 | 24 in, ductless, 2-speed | Small 24-inch cooktops |
| Broan-NuTone RL6230WH | 30 in, ductless, mesh filter | Everyday electric cooking |
| Broan-NuTone BUF403WW | 30 in, 230 CFM max, convertible | Rentals and ducted retrofits |
The white finish is a color choice and has nothing to do with sizing, so pick by width, capture design, CFM, and mounting type first. When you are ready to compare finishes and features side by side, our roundup of the best white kitchen hood for your kitchen covers tested picks across widths.
Which Mistakes Cost You The Most?
The costliest error is buying by range width alone and ignoring CFM, mounting height, and duct setup. A 30-inch hood on a 30-inch range is a starting point, not a finished decision. Comparing one model’s maximum CFM against another’s certified rating also skews the picture, so use the manufacturer’s stated figure and installation conditions. Broan’s range hood selection guidance lays out the full set of variables.
Before checkout, add the burner BTUs, decide ducted or ductless, confirm the height, and check the cabinet opening against the manual. Do those four things and the hood you install will actually pull what your cooking throws at it.
Common Questions
Can A Range Hood Be Wider Than The Cooktop?
Yes, and a little extra width helps. Broan recommends sizing 3 to 6 inches wider than the cooking surface when cabinet space and the manufacturer’s constraints allow it. The wider body catches smoke and steam that drifts sideways, which is useful for high-heat cooking or hoods mounted above the standard height.
Is A Ductless Hood Fine For A Gas Range?
It is a compromise. Ductless hoods recirculate air through a filter and cannot match outdoor exhaust at removing moisture and combustion byproducts that gas burners produce. If ducting outdoors is possible, Broan’s guidance favors it for gas cooking. Otherwise, run the fan longer and replace the filter on schedule.
Does A Higher Mount Always Mean More CFM?
Effectively, yes. Broan suggests adding 100 CFM for every additional 3 inches above the 24-to-30-inch target range, and/or widening the hood by at least 3 inches. The extra distance gives rising smoke more room to spread before it reaches the hood, so either add airflow or add capture area.
Sources
- Broan-NuTone. “Range Hood Considerations” Supports width-to-cooktop pairings, CFM rules, and mounting height guidance.
- Broan-NuTone. “Ventilation Guide 331H” Supports the 100-CFM-per-linear-foot and per-BTU airflow estimates.
- Broan-NuTone. “Range Hood Catalog” Supports model specs and listed prices for the three hood examples.