Fill a wood grinder by lifting or unscrewing its top cap, adding dry whole peppercorns or coarse salt, and replacing the cap; tighten the knob clockwise for a finer grind, loosen it for coarser.
Unscrewing the wrong part is how most people end up with a lap full of peppercorns. The cap and adjustment knob often look like one piece, so figure out which one comes off before you twist anything.
Once the body is open, three things decide whether the mill works all season: the ingredient matches the mechanism, the fill stops below the brim, and the grind setting is turned the right direction.
Opening The Mill And Loading It Correctly
The top comes off one of two ways: either the knob unscrews and the lid lifts free, or the whole top cap twists off as a unit. Peugeot’s Paris mill follows the first pattern: unscrew the top knob, lift off the top, and pour in peppercorns no larger than 6 mm.
Never fill to the brim. La Plantation recommends a maximum fill of roughly two-thirds, leaving room for grains to feed toward the mechanism. Overfilling creates resistance and can stall the grind.
- Match the mill to the ingredient — salt needs a ceramic, nylon, or corrosion-resistant mechanism, because salt’s moisture oxidizes steel and can seize it.
- Pour the ingredient straight into the wooden body, then replace the cap.
- Tighten the knob enough to seat the cap, but don’t crank it down unless you’re deliberately changing the grind.
If the mechanism feels stiff or the grind is uneven, check the fill level and ingredient first. If the body is cracked or the mechanism truly worn out, a tested roundup of wood salt and pepper grinders is faster than guessing at the store.
Adjusting Grind Size: Which Way Is Finer?
Clockwise means finer, counterclockwise means coarser on the documented models. Tightening the knob narrows the gap between grinding surfaces; loosening widens it and lets bigger particles through.
Some mills place the adjustment at the base of the top section — turn it the same way: tighter for powder, looser for cracked grain. On a few models the top knob does double duty, securing the cap and setting the gap.
Test on a sheet of white paper before seasoning food; it shows particle size clearly, from fine powder for soups and eggs to a coarse crack for grilled meat and salads.
| Ingredient | Grinder Type To Use | Size And Moisture Limit |
|---|---|---|
| Black, white, red, dried green peppercorns | Pepper mill with ceramic or steel mechanism | Whole and dry; no larger than 6 mm |
| Coarse sea or rock salt | Salt mill with ceramic or nylon mechanism | Crystals 4 mm or less, fully dry |
| Kosher or Himalayan salt | Salt mill rated for the crystal size | Dry; check the manufacturer’s limit |
| Whole dry spices | Mill rated for spices (many ceramic models) | Small, hard, bone-dry seeds only |
| Table salt, salt flakes, damp salt | None — keep out of the mill | Clogs or corrodes the mechanism |
| Pre-ground powder, wet spices | None | Packs the grinding gap and seizes |
Should You Use One Mill For Both Salt And Pepper?
No — separate mills are better, even when a ceramic mechanism can technically handle both. Pepper aroma lingers in the mechanism and transfers into the next batch of salt.
Reserve pepper mills for peppercorns and salt mills for coarse dry salt. La Plantation’s wooden mill with a CrushGrind ceramic mechanism accepts dry peppercorns, coarse dry salt, and certain whole spices, but flavor transfer still makes two mills practical. Salter’s Olea Charcoal sidesteps the confusion with interchangeable “S” and “P” caps.
Wipe the wood with a soft, damp cloth and let it dry thoroughly — Salter’s care instruction is explicit. Never soak a wooden mill; the wood swells and cracks and the mechanism rusts.
The Fill Sequence Worth Memorizing
Lift or unscrew the top, match ingredient to mechanism, fill to about two-thirds, reseat the cap, twist clockwise for finer or counterclockwise for coarser, and test on paper. The loop takes under a minute.
- Peppercorns: whole and dry, 6 mm ceiling on the Peugeot Paris.
- Salt: coarse and dry, 4 mm ceiling on the Peugeot Line salt mill.
- Powders, flakes, and damp ingredients: never.
- Cleaning: damp cloth only, air dry fully.
Three specs tell you whether a mill fits your kitchen: the mechanism material, the maximum ingredient size, and whether the adjustment sits on the top knob or the base. Peugeot’s Line salt mill runs a top button, the Cole & Mason Marlow uses ceramic salt blades, and the Salter Edith BW12616EU7 grinds peppercorns on a carbon-steel mechanism — different designs, same rules.
Common Questions
Can a wooden pepper mill grind salt?
Usually not safely. Salt attracts moisture, which oxidizes steel mechanisms until they seize. Only fill a wooden mill with salt when the manufacturer explicitly rates it for salt and the mechanism is ceramic or nylon. Otherwise keep two mills.
Why does my grinder suddenly grind unevenly?
Usually an overfilled body or damp, oversized ingredients. Empty it down to about two-thirds, check the peppercorns or salt crystals sit under your model’s size limit, and turn the adjustment knob a quarter turn clockwise to reset the gap.
How do I know which way tightens the grind?
Clockwise gives finer output; counterclockwise gives coarser. Confirm on a sheet of white paper before seasoning. Some mills place the adjustment at the base of the top section rather than on the knob, but the direction stays the same.
Sources
- La Plantation. “How to choose a pepper mill: complete guide” Covers peppercorn size limits, adjustment direction, and ingredient selection.
- La Plantation. “Wooden salt & pepper mill” Specifies the CrushGrind ceramic mechanism, two-thirds fill guidance, and compatible ingredients.
- Sur La Table. “Peugeot Line Salt Mills, 7-inch in Carbon” Documents the top-button grind control and 4 mm salt crystal limit.