A safe propane conversion kit only exists when the grill’s maker names your exact model, supplies the matching orifice, hose, and regulator set, and publishes the install procedure.
Weber flatly refuses to sell conversion kits for its gas grills, and the reason is simple: the gas train underneath a grill is a matched set of parts, not a plug. One mismatched orifice turns a controlled flame into an overfueled jet. So before you buy anything, you have to answer one question honestly — does your grill’s manufacturer authorize this exact conversion, or does it forbid the whole idea?
That single answer decides whether you shop for parts or shop for a grill. Here is how to tell the difference, what a real kit must contain, and the mistakes that keep showing up in garages.
What Makes A Kit Legitimate On Paper
The approved route runs through your owner’s manual and the manufacturer’s parts catalog, and nothing else counts. Grab the model name, model number, fuel version, and serial number off the rating plate, then search the manual for an explicitly approved kit listed against that number.
If the manual prohibits conversions, stop there. Weber’s own position is that it does not permit LP-to-natural-gas or natural-gas-to-LP conversions and does not supply kits for them, citing the complexity of the gas train and the safety risk of a mismatched setup. An unapproved conversion also voids the warranty.
A grill’s fuel identity lives in its valves, burner orifices, hose, and regulator — not in the tank fitting. Two grills can take the same 20-pound cylinder connector and still burn completely differently. That is why a bolt-on adapter proves nothing about safety.
Want to skip the guesswork and see which kits hold up in real use? Our team put together tested propane conversion kits worth buying, with the models each one actually fits.
The Parts List A Real Kit Has To Cover
A complete kit specifies every component the fuel change touches, and a kit missing one of them is a partial answer to a safety question. Weber’s guidance is blunt on this point: replacement regulators and hose assemblies must be the ones specified by the manufacturer of the outdoor cooking appliance.
| Component | What To Verify |
|---|---|
| Burner orifices | Sized and drilled for the new fuel’s pressure and heat output |
| Regulator | Manufacturer-specified model, rated for the fuel and supply pressure |
| Hose assembly | Low-pressure rated, manufacturer-specified, correct length and fittings |
| Manifold and valves | Matched to the grill model and fuel, not drilled or modified by hand |
| Mounting hardware | Included and specific to your model’s bracket layout |
| Leak-test instructions | Written procedure for every joint, not a generic leaflet |
| Cylinder spec | Standard 20-pound LP tank for most North American portable grills |
Buying on orifice size alone ignores the regulator, and a regulator pushing the wrong pressure can overheat the burners or push raw gas past a joint. Weber’s explanation of grill fuel conversion walks through why the parts are treated as one system.
Common Mistakes That Wreck A Conversion
Treating an adapter or hose as a full conversion is the mistake that starts most of them — an adapter changes a connector, not a fuel. Other repeat offenders:
- Installing new orifices without changing the regulator and checking the whole gas train.
- Assuming a kit for one model year or regional version fits another.
- Buying a kit built for cartridge-fed appliances when your grill runs a 20-pound cylinder.
- Skipping the leak test after the last fitting is tightened.
- Ignoring local inspection requirements and the warranty language.
- Running the modified grill indoors, in a garage, under a breezeway, in a tent, or beneath combustible overhead construction.
- Hooking up a dented, rusty, or valve-damaged cylinder — a cylinder can still hold gas when it looks empty.
Installations in the US follow local codes, and where none apply, Weber cites ANSI Z223.1/NFPA 54, CSA B149.1, B149.2, or the applicable recreational-vehicle codes. If your manual calls for an authorized technician, that is not a sales pitch.
When The Honest Answer Is A New Grill
Some conversions cannot be bought, and pushing past that point puts your household at risk. Weber warns plainly that LP is not natural gas — running natural gas through an LP unit, or LP through a natural-gas unit, is dangerous and voids the warranty.
If your manufacturer is in that camp, the practical move is to buy the factory-built version in the fuel you actually want, or replace the grill. A converted unit that no one will service is worth less than the parts you poured into it.
The one thing never to do after a fuel change: skip the soapy-water leak test. If you smell gas, shut the appliance off, put out any open flame, open the lid, and if the odor persists, move away and call your gas supplier or the fire department. Do not try to chase a suspected leak yourself.
One last trap worth naming. Weber’s UK adapter kit converts a gas cartridge to a 5 kg or 11 kg bottle for the Q 100/1000 series, Traveler, Go-Anywhere, and Performer Deluxe — its bottle sizes and regional spec say nothing about a US 20-pound-cylinder grill. Matching a photo of a kit you saw online to your grill is not the same as matching a part number in the manual.
Common Questions
Can I run natural gas through my propane grill?
No. Natural gas and liquid propane burn at different pressures and air ratios, and the wrong fuel in a grill’s gas train creates an unsafe condition. Weber states it voids the warranty and warns it is dangerous. Without manufacturer authorization for that exact model, the answer stays no.
Does a conversion kit void my warranty?
An unauthorized one can. Grill warranties typically cover the unit as built and as tested, and swapping fuel hardware puts the grill outside that spec. Check the warranty terms before you buy anything, and confirm in writing whether the maker authorizes the change for your model number.
Is a kit for one grill model safe on another?
No. Orifice size, regulator pressure, and manifold design are specific to the model, the fuel, and the model year. A kit that fits a visually identical grill from a different year or region can still meter fuel wrong. Match the part number to your rating plate, not to a photo.
Sources
- Weber. “Can I Convert My Gas Grill?” Confirms Weber does not permit fuel conversions or supply conversion kits, and describes standard 20-pound LP cylinders.
- Weber. Grill Owner’s Guide (PDF) States that fuel-specific parts cannot be substituted, that mixed fuels void the warranty, and lists the gas-smell and enclosed-area safety steps.
- Weber. Adapter Kit Manual (PDF) Specifies the Q 100/1000, Traveler, Go-Anywhere, and Performer Deluxe adapter kit and its 5 kg / 11 kg bottle sizing, plus regulator and hose sourcing rules.