How to Choose a Top Opening Backpack: Sizing and Capacity Guide

Pick a top-loading pack by matching liters to your full gear load and torso length to the pack’s stated range, so the hipbelt carries at least 80% of the weight.

A top loader punishes one mistake more than any other: buying the wrong size. Get capacity and torso fit right and the pack disappears on your back. Get them wrong and every mile reminds you — weight rides on your shoulders, the bottom sags, and noon gear is buried under your sleeping bag.

This guide covers liters and torso length — the two numbers that decide everything — then how to load a top-opening pack so it carries well and stays usable.

How Many Liters Do You Actually Need?

Match capacity to the volume of your complete load, not days. Cold-weather gear, bulky sleeping bags, group equipment, and long resupply gaps add liters fast.

  • Day trips and minimal overnight: roughly 20–50 L.
  • Weekend, 1–3 nights: 30–50 L is common current guidance; older charts put a 2–3-night weekend at 50–60 L for bulky gear.
  • Multiday, 3–5 nights: 50–80 L.
  • Extended trips, 5+ nights: 70 L and up.

Most backpacking packs start around 45 L and top out near 80 L. Choose the smallest pack that fits your complete intended load — extra capacity usually means carrying weight you never needed. Listed liters are total volume, pockets included: manufacturers measure by filling the pack with gumball-sized plastic balls and measuring displaced volume.

How Do You Measure Torso Length for a Backpack?

Torso length, not height, decides fit. Two people the same height can need different sizes, and small/medium/large labels mean little across brands.

Tilt your head forward and find the bony bump at the base of your neck (C7 vertebra). Put your hands on the tops of your hip bones, thumbs pointing back, and picture a line between your thumbs. Have someone measure from C7 straight down to that line while you stand upright. Also measure hip circumference around the top of the hip bones — higher than your pant waist, often a different number than your jeans size.

General torso ranges: about 15 in and under for extra-small, 16–17 in small, 18–19 in medium/regular, 20 in and up for large/tall. Hipbelts commonly span roughly the mid-20s to mid-40s in inches. These are starting points only — the specific model’s size chart controls.

How Should You Fit and Load a Top-Opening Pack?

Fit with roughly 15 lb inside and all straps loosened, then work through the straps in order. Set the hipbelt padding over the top of your hip bones, buckle, and tighten until the load rests mainly on your hips. Tighten shoulder straps by pulling their webbing tails down, draw the pack toward your lower back with the side adjusters at the hipbelt, then toward your upper back with the load-adjuster webbing at the tops of the shoulder straps. Finish with the sternum strap at a comfortable height.

Loading a top loader rewards discipline, because the bottom is hard to reach:

  • Bottom: sleeping bag and gear you need only at night — except your headlamp.
  • Middle, close to the spine: the heaviest items — food, water, stove, cook set.
  • Around the heavy items: soft clothing and tent components.
  • Top: lighter items and anything you use during the day.
  • Exterior pockets: snacks, map, sunglasses, sunscreen, first-aid kit, trowel, headlamp.

Lash sleeping pads, trekking poles, and tent poles with the external straps rather than stuffing them inside. A pack liner or dry bags keep gear organized and the deep bottom easier to dig through.

Which Mistakes Cost You the Most?

The costliest errors: choosing by height instead of torso length, assuming your pant waist equals your hipbelt size, and packing dense weight far from your back, which makes the pack sway. Loading must-haves into the bottom or sides ruins the design’s one weakness, so keep essentials high or outside. Before any trip, load the pack with your actual gear and walk around; fit and access problems show up in ten minutes, not on day two. To skip the trial-and-error, this roundup of tested top opening backpacks narrows the field by capacity and torso range. REI’s backpack fitting instructions are worth reading once before you shop.

Common Questions

Is a top-loading pack harder to pack than a panel-loading pack?

Yes, slightly. You can’t lay it flat and see everything at once, so reaching the bottom means unpacking the top layer. Disciplined packing — heavy items mid-pack close to the spine, nighttime gear at the bottom, frequently used items in exterior pockets or near the lid — solves most of the problem.

Can I size a backpack by my height instead of measuring?

Height is a poor substitute. Two hikers of the same height can need different torso lengths, and brand charts differ. Measure from the C7 vertebra to the line between your hip bones, then check the model’s stated torso range before buying.

How much weight should the hipbelt carry?

If your shoulders ache early in a hike, the hipbelt is too loose or the torso length is wrong for you.

Sources

Scroll to Top