How to Install a WiFi Door Lock with Camera? | Measure First

Camera door locks install in six steps: swap the deadbolt, mount the exterior keypad-camera, fit the interior plate, add power, test, then pair the app.

Measure before you buy. Backset, cross-bore, and the auxiliary hole must match the lock; once they line up, the install is a straight line — old bolt out, exterior unit in, interior plate on, power in, test, pair.

Which Door Dimensions Must Match Before You Buy?

A camera lock needs a wood or metal door with a 38 mm or 54 mm cross-bore, a 60 mm or 70 mm backset, and a 25 mm auxiliary hole. eufy lists those as hard requirements for the S330, and Lockly tells buyers to confirm compatibility before ordering.

The cross-bore is the hole the lock body slides through; backset is the distance from the door edge to that hole — get it wrong and the bolt lands beside the strike plate. The auxiliary hole carries spindle and camera wiring.

Check Target Measurement What Goes Wrong Otherwise
Door material Wood or metal Screws strip out of a hollow or composite core
Cross-bore 38 mm or 54 mm The lock body will not pass through the hole
Backset 60 mm or 70 mm The bolt lands beside the strike plate
Auxiliary hole 25 mm No route for the spindle and camera cable
Hub or chime reach Within about 20 ft (6 m) Weak signal and stuttering video
Charger input 5 V/2 A on the eufy E330 A weak charger drags the refill out for hours

Hollow-core, glass-panel, and thin composite doors are the usual deal-breakers — screws need solid material. If yours fails, a retrofit video doorbell is the honest fallback. Still shopping? The tested Wi-Fi door lock roundup maps models to door types.

Installing A Wi-Fi Door Lock With Camera: The Order That Saves Rework

Install with the door open and work in this order: pull the old deadbolt, feed the exterior assembly through, seat the interior plate, add power, test every entry method, then open the app.

  1. Remove the old deadbolt. Keep the screws and set the strike plate aside unless the manual calls for a new one.
  2. Feed the exterior assembly through. Align the camera-keypad and spindle in the bore, and route the cable so nothing pinches.
  3. Seat the interior mechanism. Align the mounting plate, then tighten the supplied screws evenly.
  4. Add power. Drop the rechargeable pack into its compartment, or charge it at the rated input.
  5. Test with the door open. Cycle the bolt repeatedly, then try the keypad, fingerprint, key, and app. eufy recommends repeated cycles before you trust it.
  6. Pair the app last, once the bolt moves cleanly.

eufy’s Video Smart Lock setup guide is worth keeping open on your phone — it runs the same sequence with model photos and on-screen prompts.

How Does The Lock Join Your Wi-Fi Network?

Pairing comes after the hardware works: the lock talks to a bridge or hub, and that bridge joins your router.

The eufy route runs through the eufy Security app on iOS or Android. Add the Wi-Fi Bridge first, pick Video Smart Lock as the device, choose the home profile and bridge, hold the SYNC button for 3–5 seconds until it beeps, then scan the QR code.

Lockly Vision models pair through the included Vision Connect Hub in the Lockly Home App: put the lock in pairing mode with its program button, press PR on the display, wait for two beeps, then reset the hub as Lockly describes.

Finish the camera: peel the protective film, raise your phone’s screen brightness before scanning, then set motion alerts, recording, user access, and privacy zones. Test live view and two-way audio from the porch. You’ll know it worked when the app shows the lock online with a live picture and a command retracts the bolt in a second or two.

Then shut the door and run the whole set again — fingerprint, code, key, app, forced lock. A lock that behaves on the bench and jams in the frame usually needs the strike plate nudged, not a new unit.

Common Questions

Do Camera Door Locks Need A Monthly Plan?

Neither model line does.

Will A Camera Lock Fit A Metal Or Glass Door?

Metal is fine when it is solid enough to hold screws and matches the bore, backset, and auxiliary-hole numbers. eufy lists wood or metal as acceptable. Glass-panel and hollow-core doors are the problem: there is nothing for a bolt or mounting plate to grip. A battery video doorbell mounted beside the door is the practical answer.

How Long Does The Battery Last Between Charges?

Real-world numbers swing with foot traffic — a busy hallway door filming every delivery drains faster than a quiet side entry. Lockly’s Vision Elite adds a solar panel to stretch time between swaps.

Sources

Scroll to Top