An uncoated Weber cast-iron griddle is seasoned by washing off the shipping wax, drying it fully, coating it in solid vegetable shortening, and heating it inside a covered grill for one to one and a half hours, then letting it cool in place.
A new griddle comes coated in protective wax that must come off before anything touches the cooking surface. The shortening-and-heat routine that follows takes an afternoon of mostly waiting and is the difference between a surface that releases food and one that welds it down. The order below matches Weber’s own cast-iron care instructions, with the steps that go wrong flagged.
Check The Griddle Type Before Anything Else
Only uncoated cast iron needs seasoning, so identify the surface first — a porcelain-enameled Weber griddle skips this entire process. Weber states its enamel coating resists sticking and can be cleaned with soap and water: no shortening bake, no wax-stripping wash.
Uncoated iron is dull, dark gray, and slightly rough under a fingertip. Enamel is glossy with a visible, glassy sheen.
Everything below applies to bare cast iron only.
Wash, Dry, And Coat The Bare Iron
Wash thoroughly in mild dishwashing liquid to strip the factory wax, hand-dry completely, then spread a thin, even layer of solid vegetable shortening across every corner.
Rinse with warm water, then dry with a soft cloth or paper towel. Weber is specific here: never let a cast-iron griddle drain-dry. Water sitting on bare iron starts rust within hours.
Spread the shortening thin enough that the surface looks damp rather than greasy. Skip butter and margarine this first round — Weber advises against salted fats during initial seasoning because of the salt.
Heat It Low And Slow Inside A Covered Grill
Close the lid and preheat the grill for 10 minutes, set the griddle on the grates, and heat for 1 to 1½ hours with the lid down. Then shut the burners off and leave the griddle in the grill until completely cool.
The griddle is heated indirectly by the closed grill, not blasted over open flame.
Resist cranking the dials. Cast iron holds heat well, so Weber notes extremely high temperatures are unnecessary and medium to medium-high gives the best results.
Cooling matters as much as heating. Pulling a hot griddle out early can warp it, and Weber warns cast iron can crack if dropped. Let it sit until cool to the touch.
Once seasoned, these griddles earn their counter space — our tested Weber cast iron griddle roundup breaks down which sizes fit which grills.
Keep The Seasoning Alive Between Cooks
Re-season after each use: coat with solid vegetable shortening, close the lid, and leave in the grill until cool. Scrape debris off with a steel-bristled wire brush. Never put uncoated cast iron in a dishwasher — detergent and long soaking strip seasoning and invite rust.
A cared-for surface darkens over time as the pores seal; that color shift means it is working, not a problem to scrub away. Weber recommends seasoning frequently, especially while new, since repeated coats build rust resistance.
Before storage, apply a very light shortening coat, wipe dry with a paper towel, and store somewhere dry. A rust spot comes off with the steel brush plus a fresh seasoning round — the same fix after a hot burn-off. A metallic taste or discolored food usually points to thin or uneven seasoning, or to acidic foods that ate into it.
| Step | What To Do | Timing |
|---|---|---|
| Strip the wax | Wash with mild dish soap, rinse warm, dry by hand | 10 minutes |
| Coat | Thin layer of solid vegetable shortening, all corners | 2 minutes |
| Preheat | Lid closed, burners at M-O-M (M-M on two-burner Silver A) | 10 minutes |
| Season | Griddle inside, lid closed, no flipping | 1 to 1½ hours |
| Cool | Burners off, griddle stays in the grill | Until fully cool |
| Re-season | Shortening coat after each cook, lid closed | Every use |
| Store | Light coat, wipe dry, dry location | Before storage |
Common Questions
Can I Use Butter Instead Of Shortening?
Not for the first seasoning. Weber advises against salted fats such as butter or margarine during initial seasoning because the salt works against the coating you are building. Solid vegetable shortening is recommended for the wax-stripping bake and remains best for after-cook coats.
Why Did My Griddle Turn Gray And Sticky?
A gray, tacky surface usually means the shortening went on too thick or the heat ran too high, so the fat pooled instead of bonding. Scrub with a steel-bristled brush, apply a thinner coat, and repeat the covered-grill heating at medium heat rather than a hot burn.
Does A Porcelain Griddle Need Seasoning At All?
No. Weber’s enameled cast-iron griddles come ready to cook and clean up with soap and water; the enamel handles the sticking. Seasoning an enameled surface does nothing useful and can leave a gummy film. Check the box or product page if the finish is unclear.
Sources
- Weber. “Cast Iron Griddle Care Instructions” Source for the wash, shortening, preheat, heating, cooling, and storage steps.
- Weber US. “Griddle, Model 3400248” Confirms the enameled finish, dimensions, Q 2800N+ fit, and current US price.
- Weber. “Cast-Iron Seasoning FAQ” Supports the guidance on burn-off, rust removal, and re-seasoning.