Measure your wrist one finger-width above the wrist bone, keep the tape snug and level, then match that number to the official size chart for your exact WHOOP model and band.
A band that slides during a workout leaves gaps in your heart-rate data, and a band cranked down too tight leaves marks by lunch. Neither problem starts with the strap. Both start with where you measured and which chart you read. The steps below cover the measurement itself, the placement WHOOP recommends, and the sizing mistakes that send people back to the shop for a second band.
Where The Band Actually Sits
WHOOP’s support documentation says to wear the device snug against the skin, positioned roughly one finger-width above the wrist bone. Wearing it directly over the bone, or too close to it, can reduce reading accuracy.
That placement detail is the whole reason a wrist measurement taken at the wrist crease is useless. You are not sizing your wrist. You are sizing the loop of skin and bone where the sensor will sit for the next several months, and that location sits higher up the forearm than most people assume.
WHOOP also permits moving the device slightly farther up, to about two finger-widths above the bone, as long as it stays snug and comfortable. Bicep wear follows a different rule: the band goes on the thickest part of the arm for the best signal.
How To Measure Your Wrist Step By Step
The measurement takes about a minute with a flexible tape, or two minutes with a strip of paper and a ruler. What matters is that the tape sits where the sensor will sit and stays level the whole way around.
- Pick your wearing location first. Wrist, bicep, and validated WHOOP Body positions each size differently, so decide before you measure anything.
- Find the wrist bone. Run a finger along the outside of your wrist until you feel the bony bump on the thumb side.
- Measure one finger-width above it. Wrap a flexible measuring tape around the wrist at that height, which is where the band will actually rest.
- Keep the tape level and snug. It should touch the skin all the way around without pressing into it. A loose tape reads small; a tape pulled tight reads smaller than the band needs to be.
- Using paper or string? Wrap it at the same height, mark where the end overlaps, then lay it flat against a ruler and read the length.
- Write the number down. Compare it against the official size chart for your exact hardware generation and band model, not a chart you found for an older device.
Success looks like this: the band closes with the sensor flat against your skin, you can slide one fingertip under the strap with mild resistance, and the device does not rotate when you shake your arm.
WHOOP’s own support material covers placement and fit requirements, but the published guidance does not include one universal centimeter-by-centimeter wrist chart covering every band. That is why the last step points you at the chart for your specific model rather than a single conversion table.
Band Sizes And Fit By Model: What Fits What
WHOOP 4.0 bands do not fit WHOOP 5.0 or WHOOP MG hardware, and WHOOP states this outright. Buying a strap from the wrong generation is the single most common sizing headache, and no amount of careful measuring fixes it.
| Model Or Band | Key Fit Detail | Current US Price |
|---|---|---|
| WHOOP 5.0 device | 34.7 × 24 × 10.6 mm, 26.5 g; about 7% smaller than 4.0 | Included with membership |
| WHOOP MG | Same wrist placement guidance; works with Any-Wear Pods at validated Body locations | Included with WHOOP Life |
| WHOOP 4.0 | Older hardware; its bands are not compatible with 5.0 or MG | Legacy |
| 5.0 CoreKnit Band | Everyday knit strap, 5.0 compatible | $39 |
| 5.0 SuperKnit Band | 5.0 compatible | $49 |
| 5.0 SportFlex / CloudKnit | 5.0 compatible | $59 each |
| 5.0 LeatherLuxe Straight | Uniform 25 mm width; size up if between sizes | $129 |
| 5.0 LeatherLuxe Tapered | Narrows to 14 mm on the underside; size up if between sizes | $129 |
| Meridian Band | Metal band, 5.0 compatible | $149 |
Two fit notes hide in that table. LeatherLuxe bands carry a specific instruction to size up when your measurement lands between sizes, then use a smaller ringlet to fine-tune the fit. The straight and tapered versions also differ in construction, so a straight band and a tapered band of the same nominal size will not feel identical on the wrist.
Wrist bands and bicep or Body-location accessories are not interchangeable either. If you plan to switch between wrist and arm, measure both locations.
For readers who want a different look without guessing at fit, this roundup of rose gold wrist bands that fit WHOOP pairs finish options with the hardware generation each one matches.
Common Sizing Mistakes And How To Avoid Them
Most sizing failures trace back to one of five habits: measuring at the wrist crease, measuring over the bone, borrowing a size from a 4.0 chart for a 5.0 band, assuming 4.0 straps will clip onto newer hardware, or wearing the band loose enough to break skin contact during movement.
There is one more trap worth naming. Someone measuring 165 mm who sizes down to a snugger band often ends up with a strap that pinches by the afternoon, because skin and tissue shift through the day. When you land between two sizes on a LeatherLuxe band, WHOOP’s guidance is to take the larger one. Snug is the target; tight is not.
Fit problems and discomfort are different things. The published WHOOP sources cover placement and sizing but offer no medical guidance on circulation, skin reactions, or wearing the device during an injury. If you feel numbness, pain, discoloration, or see a rash under the band, take it off and talk to a professional rather than adjusting the size again.
Battery runtime tells you nothing about fit, so don’t let it pull your attention away from the measurement.
Common Questions
Should I measure my wrist at the crease or higher up?
Higher up. WHOOP’s support guidance places the band about one finger-width above the wrist bone, so your tape should sit at that same height. Measuring at the crease, where a watch band usually rests, gives you a smaller number than the band actually needs. Shift the tape up and measure again if your first reading came in at the crease.
What if my measurement falls between two sizes?
It depends on the band. For LeatherLuxe models, WHOOP specifically recommends sizing up and then using a smaller ringlet to tighten the fit. A larger band with a ringlet adjustment gives you room to fine-tune, while a smaller one leaves you stuck if your wrist swells in heat or after a long workout. Check the chart for your exact band model before deciding.
Can I use my old WHOOP 4.0 bands on a 5.0 or MG device?
No. WHOOP states that 4.0 bands are not compatible with WHOOP 5.0 or WHOOP MG hardware, so an old strap will not clip on properly regardless of size. Any band you order for a newer device needs to be a 5.0-compatible model. This also means a size you memorized from a 4.0 chart tells you nothing useful about which 5.0 band to buy.
Sources
- WHOOP. “WHOOP Accessories: Overview & Recommendations” Source for wrist placement, one-to-two finger-widths above the wrist bone, snug fit, and LeatherLuxe sizing-up guidance.
- WHOOP. “WHOOP Basics” Covers basic wear guidance and device orientation on the body.
- WHOOP Shop. “5.0 Bands” Current US listings and prices for 5.0-compatible band models.