Wooden Hammock Stand Sizing Guide: What Dimensions You Need

A wooden hammock stand must be matched to your hammock’s ring-to-ring length, not its fabric bed, plus the stand’s full footprint and published weight limit.

A hammock that measures 78.7 inches of fabric can still need more span than a stand’s listed range allows once the suspension chains are hooked on. That gap between the cloth length and the ring-to-ring span is where most sizing mistakes start, and it’s the number worth getting right before you buy anything.

The checks below walk through the exact measurement to take, two real stands for comparison, and the mistakes that cost people a return shipment.

Measure The Hammock First: Ring To Ring

The number that matters is the distance between the two metal rings on an unloaded hammock, measured where the suspension hardware attaches. Fabric-bed length is a different figure and will undersize your stand.

Lay the hammock flat and stretch it gently. Hook your tape at one metal ring and pull to the opposite ring. Write that number down before you shop, because product listings quote hammock length and stand length as separate specs and they are not interchangeable.

Then check the stand’s stated supported range against your ring-to-ring figure. A stand advertised as “13 ft” may support a narrower actual span, so confirm the manufacturer’s fit instructions rather than trusting the marketing label.

Wooden Hammock Stand Dimensions That Fit

Stand footprint, width, and height all need to clear your space, not just the length. A 162-inch stand runs 13.5 feet before you add room to step in and swing.

Two current US listings show how far apart the specs run:

Spec Atesun 13.5-Ft Stand Outsunny 84A-157 Stand
Overall length 13.5 ft (162 in.) 128 in.
Width × height Not listed in brief 47.25 in. × 46.5 in.
Weight capacity 475 lb 264 lb
Stand weight 84.4 lb 37 lb
Capacity label Two-person One-person
Hammock included Yes, quilted bed Stand only
Bar material 55-in. hardwood bars Solid wood
Listed price $350.21 $157.99

The Atesun listing quotes a 78.7-inch hammock-length figure, which is not the same as a required ring-to-ring span — confirm assembly and fit details before assuming it matches your hammock. The Outsunny page notes assembly is required and does not include a hammock.

If you’d rather compare tested stands side by side, our roundup of wooden hammock stand picks lays out the trade-offs in one place.

Weight Limits And Assembly Details

The published pound limit covers the user plus the hammock and any accessories, and a “two-person” label never overrides the number. Stay under the stated capacity.

The two listings above range from 264 lb to 475 lb, which is a wide enough spread to matter for couples. Use only the chains, carabiners, and eyebolts the manufacturer supplies or approves. Tighten every structural bolt during assembly and recheck fasteners before the first sit. Keep the stand on level, stable ground.

Wooden stands live outdoors, so inspect the wood, bolts, chains, carabiners, and finish on a regular schedule — looseness and weathering show up early if you look.

Where Sizing Goes Wrong

Most bad fits trace back to five avoidable errors:

  • Choosing by a marketing label like “13 ft” instead of the actual supported ring-to-ring range.
  • Confusing the hammock’s 78.7-inch bed length with the suspension span the stand requires.
  • Ignoring width and height when planning a patio or porch spot.
  • Reading “two-person” as permission to load past the published pound limit.
  • Assuming a hammock ships with the stand — several are stand-only products.

Spreader-bar hammocks need extra care. Confirm the suspension geometry matches the stand’s design from the individual product spec, because a stand built for gathered-end hammocks may not suit a bar hammock.

Retailer prices, availability, and warranties shift, so treat the figures above as current examples rather than permanent values.

Common Questions

Should I measure the hammock fabric or the rings?

Measure ring to ring with the hammock unloaded. The metal rings mark where your suspension hardware attaches, so that span tells you what the stand actually has to support. Fabric-bed length runs shorter and will point you toward an undersized stand.

Can a two-person stand hold two adults every time?

Only if their combined weight plus the hammock stays under the published limit. The Atesun example lists 475 lb and the Outsunny lists 264 lb, so check the number on your specific stand rather than trusting the capacity label.

Do wooden hammock stands come with a hammock?

Sometimes, but not always. The Atesun stand includes a quilted bed and the Outsunny stand does not, so read the listing before you buy. If yours is stand-only, size your existing hammock’s ring-to-ring span against the stand’s range first.

Sources

Scroll to Top