A one-car wooden carport needs roughly 12 feet of width and 20 feet of depth to clear open doors and mirrors, so measure your vehicle’s full footprint before comparing any kit.
Most carport regrets start the same way: the buyer measures the car’s body and forgets the mirrors. A typical one-car target of 12 ft wide by 20 ft deep leaves working room on all four sides, while the commonly cited 10 ft × 18 ft minimum is tight enough that door swings, snow clearance, and maneuvering all get pinched. Getting the number right takes about fifteen minutes with a tape measure and one extra pass around the vehicle.
What Should You Measure Before Sizing A Wooden Carport?
Measure the vehicle at its widest and tallest points, then add clearance around every side — never size the structure to the tire footprint alone.
- Width: include both mirrors extended, not folded.
- Length: include hitch, spare tire, and rear bumper overhang.
- Height: include roof rails, antenna, and any roof box or bike rack left mounted.
- Clearance: add room for door swing, walking space, tailgate drop, and stored gear.
A manufacturer sizing guide suggests allowing about one meter of space around the vehicle for doors and maneuvering, listing roughly 2.5–3 m wide by 5 m long for a typical single car. That guidance is general and not a US code requirement, but it lines up with the practical US targets below.
What Wooden Carport Size Fits Your Vehicle Count?
Match the footprint to how many vehicles the carport must hold, then check the height against your tallest roof line.
| Layout | Standard Footprint | Minimum Cited |
|---|---|---|
| One vehicle | 12 ft × 20 ft | 10 ft × 18 ft |
| One vehicle plus storage | 18 ft × 20 ft | — |
| Two vehicles side by side | 24 ft × 20 ft | 20 ft × 18 ft |
| Two vehicles end to end | 12 ft × 40 ft | 10 ft × 36 ft |
| Three vehicles side by side | 36 ft × 20 ft | — |
| Minimum height cited | 7 ft | — |
The commonly cited 7 ft height clears sedans but not much else. The same manufacturer guide gives indicative interior heights of 2.20 m for city cars and sedans and at least 2.40 m for SUVs or 4×4 vehicles. Trucks, vans, and anything with a roof box need more than either figure, so measure the total height with the tallest accessory mounted.
How Do Advertised Dimensions Compare To Usable Space?
Advertised footprint describes the roof or foundation outline, not the clear space your vehicle actually occupies — compare usable interior dimensions instead.
Timber kits are commonly sold from 3.0 × 6.0 m through 7.5 × 6.0 m, and published tables list external dimensions only. One 3.0 × 6.0 m model carries an 18 m² footprint with 2.23 m eaves and a 2.75 m ridge; a 6.0 × 6.0 m Eco version runs 36 m² at 2.30 m eaves. Because those figures are external, the clear opening, eaves height, and any diagonal braces or cross-beams all eat into the space you thought you bought.
Check the lowest obstruction — eaves, beams, gutters, and lights — against your vehicle’s total height, not its roof line. A carport with a 2.20 m eaves height can still foul a roof box that clears the ridge by inches. Values listed for European kits, including prices in euros, are not US delivered pricing and should not be treated as a US cost benchmark. If you want to compare finished kits before committing to dimensions, our tested wooden carport kit rankings cover the models we’ve actually evaluated.
What Do Local Codes And Site Conditions Change?
Permit rules vary by city, county, zoning district, attachment status, and footprint size, and some jurisdictions require a permit for a carport of any size, prefabricated kits included.
Portland, Oregon, states that detached, one-story, nonhabitable accessory structures of 200 square feet or less may not require a building permit, while also requiring 18 ft from a street property line and generally 5–10 ft from other property lines. San Diego’s carport guidance says a carport must be open on at least two sides and cannot exceed 1,000 square feet or one story. Fairfax County publishes construction details worth reading for structural and attachment requirements.
Confirm the site fits the full footprint plus roof overhangs, drainage, setbacks, and driveway access, and select a structure engineered for local snow, wind, and seismic loads. Sizing the carport correctly and anchoring it to code is the difference between a shelter and a liability.
The vehicle you park decides the dimensions. Write down the widest, longest, and tallest measurements with mirrors, racks, and hitches included, stack the clearance for doors and walking space on top, round up to the nearest standard footprint, and verify the eaves — not the ridge — clears your tallest point. Then check the site plan and call your local building department before ordering a kit.
Common Questions
Do I Measure Mirrors When Sizing A Carport?
Yes. Extended mirrors can add six to ten inches to a vehicle’s width, and a carport sized to the body alone will leave the mirrors clipping posts or forcing you to fold them every time you park. Measure the widest point, then add clearance on both sides.
Is A 10 × 18 Carport Big Enough For One Car?
It can work for a compact sedan if you fold the mirrors, but it leaves almost no room for door swing, snow piling, or walking around the vehicle. Most drivers are better served by the 12 × 20 target once real clearance is counted.
Do I Need A Permit For A Wooden Carport?
Possibly, even for a small kit. Rules depend on your city, county, and zoning district, and some jurisdictions require a permit for a carport of any size. Check with your local building department before ordering.
Sources
- City of San Diego Development Services. “Information Bulletin 205 — Carports.” Establishes open-side and 1,000 square foot limits for carports.
- Portland Permitting & Development. “Building Official Determination BOD 21-01: Carports Under 200 sf.” States the 200 square foot threshold and property line setbacks.
- Fairfax County Land Development Services. “Carport Details.” Provides structural and attachment construction details.