A 5.0-cubic-foot washer measures roughly 27 inches wide and 39 to 45⅜ inches high, but depth swings from 28⅜ to 33¼ inches depending on whether the model is top-load or front-load.
An empty-alcove measurement tells half the story; the lid arc on a top-loader or the open door on a front-loader eats space a cabinet measurement never shows. Below are real dimensions from current LG listings, the clearances that break installations, and the number most people forget before delivery day.
What Are The Actual Dimensions Of A 5 Cu Ft Washer?
Every current 5.0-cubic-foot LG model in the manufacturer data is 27 inches wide. Height and depth split by type: top-loaders run 40⅜ to 45⅜ inches tall with 28⅜ inches of depth, while front-loaders sit around 39 inches tall with 33⅛ to 33¼ inches of depth. A front-loader trades height for depth because the drum sits behind a door rather than under a lid.
| Model & Type | Dimensions (W × H × D) | Space With Lid Or Door Open |
|---|---|---|
| LG WT7150CW (top-load) | 27 × 44½ × 28⅜ in. | 57⅕ in. high, lid open |
| LG WT7300CV (top-load) | 27 × 44½ × 28⅜ in. | 57¼ in. high, lid open |
| LG WT1901CK (top-load) | 27 × 40⅜ × 28⅜ in. | 55⅜ in. high, lid open |
| LG WT5680HVA (top-load) | 27 × 45⅜ × 28⅜ in. | 55¾ in. high, lid open |
| LG WM4200HWA (front-load) | 27 × 39 × 33¼ in. | 55 in. deep, door open |
| LG WM3470CW (front-load) | 27 × 39 × 33⅛ in. | 57¾ in. deep, door open |
Capacity and footprint are separate measurements: cubic feet describes drum volume, and two 4.5+ rated washers can carry different exterior dimensions. Read the exact model’s spec sheet, not the retailer’s generic listing.
Washer Dimensions And Space Requirements: Where The Fit Actually Fails
Installations rarely fail on cabinet width. They fail on operating clearance — space above an open lid, in front of an open door, and behind and beneath the cabinet for hoses, cords, and leveling feet.
Top-loaders need roughly 55⅜ to 57¼ inches from floor to ceiling at the lid’s highest point; check that against countertop overhangs, shelves, or a dryer mounted above. Front-loaders need 55 to 57¾ inches of front-to-back clearance with the door swung wide, plus standing room.
Delivery access is its own obstacle course. Walk the route with a tape measure and check doorways, hallway turns, and stairway landings against the carton dimensions, which run several inches larger than the product.
- Behind the machine: hot and cold hoses, the drain hose, and the power cord project beyond the cabinet back. Leave a few inches for service access.
- Underneath: leveling feet adjust the height slightly, so a tight opening can turn into a jammed one.
- On top: a pedestal adds height.
Once the machine fits and runs, matching it to the rest of your setup matters just as much — our tested 5 cu ft washer roundup covers models side by side if you are still choosing.
How Do You Measure A Laundry Space Correctly?
Measure the opening at three points — top, middle, and bottom — for both width and depth, since drywall, trim, and baseboards are rarely square. Record the smallest number in each direction as your true limit. Then measure the full delivery path and the operating clearances the model demands; LG’s product pages list exact lid-open height or door-open depth per model alongside the carton size. Installation must follow the model’s owner’s manual and your local plumbing and electrical codes for water lines, drain height, and outlet placement — the manufacturer’s instructions govern, not a generic online guide. For current specs, the LG WT7150CM product specifications show how dimensions and clearance data are presented.
Add a couple of inches of margin to every measurement. A machine that clears the doorway by half an inch scrapes the trim, and a lid that opens with a quarter inch to spare will not stay that way once the washer walks on an uneven floor.
Common Questions
Is a 5.0 cu ft washer the same size as every other 5.0 cu ft model?
No. Cubic feet measures drum capacity, not exterior size. Two washers rated at 5.0 cubic feet can differ in height by several inches and in depth by nearly five, depending on top-load or front-load design. Always check the exact model’s dimensions.
How much clearance do I need above a top-load washer?
Enough for the lid to open fully without hitting anything. Current LG top-loaders reach roughly 55⅜ to 57¼ inches from the floor with the lid up, so measure ceiling height, shelving, and wall cabinets against that figure.
Can a 5 cu ft washer fit through a standard doorway?
Measure doorways and hallway turns against the carton size, not just the appliance, and remove packaging before the final squeeze.
Sources
- LG USA. “LG WT7150CM Top Load Washer Specifications.” Source for top-load dimensions, lid-open height, and carton size.
- LG USA. “LG WM4200HWA Front Load Washer Specifications.” Source for front-load dimensions, door-open depth, and pedestal size.
- LG USA. “LG WT7200CV Top Load Washer Specifications.” Source for top-load clearance and carton measurements.